Televisions

[Terhoeve]

Just got this TV. I don't wish to go through over 20 codes to have my AT&T remote work. The ATT Uverse box is a motorola vip 1200 the TV remote number is NS-RC01G-09 and the tv model is listed above (32 inch 720p (no dvd built in). Your help is appreciated in giving me the code to work it.

Thanks.

[John-INSG · Accepted solution]

Hello Terhoeve,

Welcome to Community@Insignia™!

You might want to give this solution a try, or contact AT&T for additional options.  I hope this helps.

Regards,
John
Insignia™ Support

[Terhoeve]

Hi The solution offered doesn't work. Maybe this particular owner had a older version of the AT&T U Verse box/ U verse remote. Well let go play another 2-3 hours with the remote to see if I can get it to work or spend 120 buxks on a Harmony 700. Sheesh nice. Maybe I should of gotten the Samsung 32 inch after all. At least they have the codes for it.

[Terhoeve]

Hi I went back through the programming again on the uverse remote and it works now. I had to use the ff and play button to get to the right code (starting from # 922). Now I just have to resolve a question about the picture and I am happier then a clam. Please set up a AT&T uverse remote on your support page.

Thanks.

[UverseNazi]

1023 This code worked for me.

BTW this thread is horrible and none of the above solutions worked for me. I had to use google to sort the matter out. Here is the link where I found the answer. http://wiki.answers.com/Q/What_are_the_att_u-verse_remote_control_codes_for_an_insignia_lcd_tv

Hope this helps!

Steps to Program U-Verse Remote

Step 1: Press "TV" Button and then Press "Ok" Button (The lights on the remote will then flash)

Step 2: enter the code 1023 (then just wait)

That should be it. You remote should now power your TV on and Off at the same time as the ATT U-Verse Box. Which is what I assume most of you want. The Uverse Box can then control the volume. If you find that your set is too loud or too quiet, Use the Insignia remote to set the master volume. (I set my Insignia Vol to mid way and then pascked the remote away. I now use the UVerse remoet to control the vol)

Thanks

Matt

[webneophyte]

I tried 1023 and 1033.  I have AT&T remote and a NS-32L450A11 TV.  Any other suggestions?

[webneophyte]

Now that's it's darker in the room, I noticed that when I pressed TV then OK, the lights did not flash. So it must not be taking the codes.  What am I doing wrong; any ideas?

[webneophyte]

hold the TV and the OK buttons at the same time...