Reply
Visitor
bnemo
Posts: 2
Registered: ‎07-24-2010

Question on plugging in a new power supply board - NS-32LCD

 

Hello,

 I have a NS-32LCD Insignia. My power supply board went bad (had it diagnosed by a technician) and I ordered a replacement. Problem is, I sent my bad board out (for the core charge) before the replacement got here. There is one 'ribbon' cable that I have a question about. In the below picture I am pretty sure the cable (marked by the upper arrow) goes into slot 2 and not slot 1. If anyone could verify that for me I would be very grateful. The power supply board is a 782.32FB26-2000

 

Visitor
bnemo
Posts: 2
Registered: ‎07-24-2010

Re: Question on plugging in a new power supply board - NS-32LCD

Well... no posts, so I went with my gut instinct...put it in slot 2 and everything appears to be working just fine

Newbie
mikebailey2000
Posts: 3
Registered: ‎02-07-2011

Re: Question on plugging in a new power supply board - NS-32LCD

How hard was this to swap?